Slashdot Mirror
New Ship Will Remain Stable By Creating Its Own Inner Waves
Zothecula writes "When offshore oil drilling rigs are being installed, serviced or dismantled, the workers typically stay in cabins located on adjacent floating platforms. These semi-submersible platforms are towed into place (or travel under their own power) and then their hulls are partially filled with water, allowing them to remain somewhat stable in the pitching seas. Now, a ship is being built to serve the same purpose, but that will be a much more mobile alternative. It will keep from rolling with the waves by generating its own waves, inside its hull."
I used to do that in my bathtub. It's nice to see someone finally upscaled it like this.
I don't expect you are trying to assert that in such a case a spokesman of the administration telling us that the reason we are planning to engage in an act of war is something he cannot speak of. Is he a) telling us we cannot know the reason? b) lying? c) telling us he does not know the reason? or what? None of these cases are even remotely acceptable. We aren't talking here about raising taxes or birth certificates you know, people are going to die based on this.
And Kerry, good grief.
Wait, wait, wait...
Kerry's new defense for action in Syria is that if we DON'T intervene, MORE extremists will be attracted to the cause.
LOLWUT?!
Old and Busted: Intervention Incites Extremism
New Hotness: Nonintervention Incites Extremism
BEYOND. PARODY.
Carbon is an chemical element.
Smoke is made of carbon.
Chris Stevens died of smoke inhalation.
I guess Pres. Obama doesn't care when our enemies use chemicals to kill Americans.
He must have drawn his Red Line at YouTube videos.
To helps me gets my grooves on without losing my babe inside the folds of my water bed.
Where I come from, we still refer to ships with the feminine pronoun.
The system pushes water from side to side using compressed air to counteract rolling from ocean waves. Granted this is for use in drilling rigs (read big money), but I wonder how much power is required to run the air compressors. The compressors have to be high flow to rapidly move a lot of water, albeit at relatively low pressures-- only 4.4 psi required to generate 10ft difference in seawater (this does not take into account viscosity and inertia).
Reminds me of the chapter in Neal Stephenson's The Confusion (part of The Baroque Cycle). Japanese mercury vendors try to disable the Minerva (an armed merchant vessel) by filling its cargo hold with half-filled pots of mercury, rather than filling them to the brim. The idea is that the sloshing in the hull would resonate with the waves at the entrance to the harbour and slow the ship enough to be captured (or something to that effect). There's a discussion of whether Stephenson got the science correct here.
When you have nothing left to burn you must set yourself on fire
I claim patent infringement. Now give me money so I may pay my lawyers.
Haven't they learned that the best way to survive is NOT to make waves?
#DeleteChrome
This has been done for a few years now. Fuel and potable water tanks in the ships sides connected via pipes with computer controlled valves. Some sailboats include pumps to actively move liquid to the windward side tanks to decrease heeling.
Have gnu, will travel.
They had better get it right. When I use to drive a tractor/tanker, if you didn't get your 1st an 2nd gear shifting just right, the chemicals in the tank would shift with such extreme force, that it would almost knock your head off. You can easily hurt your back driving a tanker. I can just see a ship getting the wave out of sink and bursting a hold in the hull.
Traditionally sailors accomplish this by slowly filling the ships bilge with vomit.
Small Waterplane Area Twin Hull (SWATH) is a design that minimizes the effect of the waves. Most of the volume that supports the ship is below the level of the waves, making it very stable. The stability comes from the hull design, so it doesn't require any power and the stabilization isn't prone to failure like an active system.
Here's a short video of a SWATH ship in rough seas, with a regular hull ship for comparison. I'm pretty sure this is the one that I saw in a documentary about the design. They showed a glass of water sitting on a table in the SWATH ship, not spilling. I'm pretty sure that the glass would go flying in the other ship.
More than just a few years now... try a few decades. (More like a century in fact.) They're called anti-roll tanks, and were first used around the turn of the 20th century.
(Naval architecture geek FTW!)
Yep. These anti-roll or flume tanks have been around for a very long time, both passive systems and active ones like this. Basically they use the free surface effect in reverse by slowing down the sloshing of water in a tank so it counteracts rolling instead of adding to it.
However, if the roll period of the ship and the movement of water in the tank synchronize, you have only second to act before it can roll the ship to a dangerous degree or capsize it outright. They're fitted with dump valves to the port and starboard, just in case...
Anti-roll tanks have been around for a while. They're tricky to tune, but if you have enough money, I guess they're worthwhile.
http://en.wikipedia.org/wiki/Antiroll_Tanks
Like the Ocean Ranger though, I wonder how fucked they'll be if someone leaves a porthole open and the control box gets wet.
http://en.wikipedia.org/wiki/Ocean_Ranger
See Den Hartog (1956) 'Mechanical Vibrations" for description of ship stabilization using this method a century ago. It was supplanted by the Sperry system in the 1930s.
This isn't inner waves, but water moving back and forth in a U shaped tank (water is pushed by compressed air on the tops of the U shape, alternatively).
So there's no wave at all in the tank.
I just wonder:
Is the counter-reaction mainly cause by the counter-weight of the water which fills only one side of the U tank, or by the momentum (acceleration) given to the water rolling in the tank ?
In either case, it could be more easily done with some solid weight on rails, with less energy lost (air compression and fluid displacement).