Why are you being so critical? I can give you a through hole board in a few hours but an smd board is much harder. Like I said I scrapped a blank board recently. Throwing money at a problem is not a skill I value. Your comments don't contain any information.
I have tried all but the photosensitive boards. I have heard good reviews of that method but I don't see the point because my etching results have been unreliable. Doesn't everyone need a quick turnaround these days? I was hoping for TIPS AND ADVICE but maybe I was expecting too much.
My comments here reduce to one sentence.
There must be a better way.
Even for a professional having a DIY circuit board ability would be a great benefit. Allowing engineers to test their PCB before having many produced and to go through many design variations before deciding on a final product. Where are all the engineers when you need them? Are there even any corporate insiders with trade secrets to share?
Slashdot Mirror
Why are you being so critical? I can give you a through hole board in a few hours but an smd board is much harder. Like I said I scrapped a blank board recently. Throwing money at a problem is not a skill I value. Your comments don't contain any information.
I have tried all but the photosensitive boards. I have heard good reviews of that method but I don't see the point because my etching results have been unreliable. Doesn't everyone need a quick turnaround these days? I was hoping for TIPS AND ADVICE but maybe I was expecting too much. My comments here reduce to one sentence. There must be a better way.
Even for a professional having a DIY circuit board ability would be a great benefit. Allowing engineers to test their PCB before having many produced and to go through many design variations before deciding on a final product. Where are all the engineers when you need them? Are there even any corporate insiders with trade secrets to share?