Amateur Radio Packet Over 802.11 Cards

Skuld-Chan writes: "I stumbled across this the other day -- basically discusses modifying common 802.11 boards for amateur radio bands (or Part 97 rules). Under Part 97 there is a 100 watt limit and no gain limit (unlike the 6 db gain limit on Part 15). I thought it was interesting :)." Consult your friendly branch of the FCC :) Note that this is just one of several interesting projects from this site.

Comments

Re:If I had speakers that handled it..

[Chanc_Gorkon]

Music and amatuer radio doesn't mix (not sure if the data would be though like if it would be a MP3....). The only station allowed to broadcast music on the amatuer bands is the space shuttle.

Re:interference

[Perdo]

A microwave oven has a "white" high power amplifier inside. It tries to transmit as close to 2.4 Ghz as possible, as this is the resonate frequency of water molecules. The actuality is they produce a more "white" RF, like a white lightbulb produces a broad spectrum of light compared to a laser. Any saw filter placed on such a transmitter, would get very hot indeed, and would waste the energy that could be used to heat the food. The filter would get hot instead of the food.

Since the RF is white, there is no way to design a feedhorn or antenna to properly radiate the power. High VSWR would kill the transmitter in a very short period of time. Food in the microwave acts like a dummy load. It absorbs the RF, so little gets reflected back into the transmitter. VSWR as low as 15% of total power out of a klystron will make it explode in just a few seconds. The electrons "piling up" forces the klystron to act like a capacitor, and the electron gun will arc with the collector, causing the glass vacume chamber surrounded by rare earth magnets to implode with a force compounded by the high voltage being applied to it.

Suffice to say, a klystron out of tune or improperly capacitance match with it's antenna goes like a grenade.

Make sure you disable the power supply safety interlocks and bypass the fuses in addition to cutting a hole in the door of the microwave to achieve this effect.