Slashdot Mirror
Pro/Engineer Coming to Linux
PotatoHead writes "
Parametric Technologies Corporation
(PTC) announced in a recent
press release, a Linux port of their flagship modeling product Pro
Engineer. HP will be the preferred partner for the Linux platform
release. This is pretty big news for the engineering and product design
crowd folks. There must be some fairly credible requests coming in for
this to happen."
This is top-notch software. Well, PRO/Engineer is, anyway. The last shop I worked at used Cadence but we had a lot of PRO/E CAD people who had come from Lockheed-Martin.
OTOH, this is not cheap software. Usually several thousand $$ a seat.
Learning HOW to think is more important than learning WHAT to think.
I have been in ASIC engineering for the past 11 years. I have seen things moving towards Linux as the underlying OS for the past 2-3 years.
It appears to go hand in hand with the fastest uniprocessor platforms looking fast compared to the fastest uniprocessor suns.
The software we use is very expensive and generally compute intensive. So it pays to run it on the fastest hardware and it pays to buy the fastest hardware when it is the cheapest. The only exceptions are tools that require 64 bit addresses to permit enough memory to be installed (E.G. IC layout). Sun still wins there.
When PCs are both the fastest and cheapest and Unix is the operating system of choice for engineers and Linux is both free and good, the preference is obvious.
We pretty much will not buy software that does not run on Linux and the ASIC tool vendors know it.
The same market forces seem to apply in here mechanical engineering.
I should use this sig to advertise my book ISBN-13 : 978-1501515132.
ProE started on the Unix platform, then almost totally migrated to NT (and 2k). But they kept the same kind of interface, which needed some time to get used to (all menus in a single window, the next of which overlaps the previous...). They had the potential to really take the market with their parametric technology, which was a lot more advanced than what AutoCad could (can) offer. But then some other ones rose...
Personnally, I'm leaning towards SolidWorks. The licensing costs are smaller than those of the competition, and it's very pleasant to work with. Very Windows-centric, but the interface is fast to get accustomed to.
And it impossible to pass by Catia V5. The precedent versions were almost exclusively Unix-based, but they also made the switch to NT. The interface is really nice (reminiscent of XP, but a few years before). Pleasant to use, but V5 is still being developped, so the stability on the latest release is not always top notch.
There's also Autodesk's Inventor, although I never used it personally.
Of course, then there's the support for third-parties modules. This can hurt initialy the introduction of a new platform (CAD or HW).
Kudos to PTC for bringing their product to Linux. I know there's been some people asking them to do it for a few years now. But one has to wonder if it's because they feel some pressure to maintain their share of the market.
Why oh why has Autocad not been released for Linux?
AutoCAD used to be available for a number of the proprietary *nixes (Solaris, SGI IRIX, HP/UX, etc) back in the Release 10, 11, 12 (and early R13) days. People I used to know that worked at AutoDesk used to make sort of veiled hints that Microsoft put some kind of pressure on them to quit supporting alternative platforms. More or less what they were saying is that AutoDesk was told if didn't quit supporting non-Microsoft platforms that Microsoft would enter the CAD market (possibly by buying up one of AutoDesk's competitors), or at least announce that they were going to, and that would kill AutoDesk by "giving away" the product. But of course nobody in those days would dare come right out and say something like that.