Slashdot Mirror
Taiwanese Capacitors Leaking, Exploding
ackthpt writes "A few astute slashdot readers were on to something back when this article was published. After a tip (at e-insight.net) on failing caps over at amdmb I did a little looking around and found this article by Dennis Zogbi on TTI Inc.'s site, which goes into more detail. In a nutshell, many motherboards are now failing due to electolytic capacitors made with an inferior water-based electolyte. Within days or a few months these capacitors build up hydrogen gas and blow the rubber bung out the end of the capacitor, leaking electolyte and causing havoc. The problem may be widespread, as many consumer electronics made with these capacitors may also fail prematurely. Gary Headlee specializes in Abit motherboards, but as his FAQ states, he will work on other makes and the FAQ has more info on capacitor problems."
Rubbish. What are you xenophobic?
Unless you buy a known grade of electronics you have no hope of getting stable, reliable kit. American or otherwise. Quality costs period.
If you've used a cheap board for a mission critcal server then who is at fault? It ain't the supplier.
What a comfortably short memory you must possess.
The reason electronic parts manufacturers in the United States lost market share to foreign makers in the first place was the shoddy workmanship of the US companies' products. Like the US Auto companies, they exaggerated the importance of their own prestige and assumed that this guaranteed competition did not matter, so they inflated their profits by shipping bad parts. The machine control manufacturer I worked for in the 1980s, when trying to purchase parts, would receive shipments that fit into two classes: The ones where the 10-15% non-operating parts were scattered throughout the shipment, and the other variety where the manufacturer had tested the parts, then placed what they already knew were the bad ones in the bottom of the cartons in the hope that they would thus slip by incoming inspection.
It was not until foreign companies began to supply the parts as well, usually with failure rates so low the incoming inspections were no longer necessary, that the US companies realized they could no longer get away with this crap, and began to get their own act together.
Worst case scenario: protectionism placing non-US manufacturers under a handicap with regards to US electronic parts makers - inevitable result would be the domestic suppliers slacking off on their quality again.