IOGEAR Homeplug Networking Reviewed

Chris Allen writes "Wired or wireless? This is always just about the first thing anyone thinks of when planning their new home/soho office. It always comes down to price/performance/practicality, in whichever order you feel is more important. Sometimes it just isn't possible to run CAT5, for a variety of reasons. The only options available for the average consumer is wireless, HomePNA, which uses your existing telephone network in your house, and HomePlug, using your existing power grid. HomePNA has been around for around 3 years or so, and has matured some, starting out transmitting at dismal speeds and lackluster reliability in regards to interference. HomePlug is short for HomePlug® Powerline Alliance."

Comments

Not the best solution

[wowbagger]

The characteristic impedance of TV co-ax is 75 ohms. Thinnet Ethernet cable is 50 ohms, as is the impedance of an Ethernet card. This will cause a VSWR mismatch.

You are getting a reflected signal off each network card in the system. As you describe it, you have a simple point-to-point link, so your reflections are "only" bouncing from one card to another. This will cause errors in the system.

I would suggest that you get REAL network cable (preferably CAT-5), tie it onto the existing cable, and pull it through. You will then be able to run 100Mbit, you won't have the reflection problem, and I think you will be much happier overall.

(actually, I would suggest that you go to the local hardware store, and while you are picking up the CAT5, pick up a spool of nylon cordage. Strip the end of the coax, and securely tie the cordage to the shield of the coax. Then smoothly tape it over with electrician's tape, starting on the coax jacket and with a 1/3 overlap moving to the cordage. When you reach the cordage, wind one extra pass, then cut the tape and UNWIND and REWIND that last wrap with no tension on the tape. Then pull the cordage through. Once it is through, then tie the CAT5 to the cordage and tape as you did the coax. Then pull BOTH the CAT5 and a new run of cordage. Leave the cordage in place - it will save you grief later if you need to pull an additional cable.)