What's Worse for Hard Drives: Heat or Vibration?

gottabeme asks: "I turned on my computer the other day and all of a sudden the BIOS said the S.M.A.R.T. status was "Bad: backup and replace." The drive has continued working in PIO mode (instead of DMA) long enough for me to get a new drive and copy everything over. When I finished copying and put the new drive in the cage where the old one was, I realized that the fan at the front of the cage which was keeping the drive cool to the touch was causing a fair amount of vibration to be transferred to the hard drive. The other 7200rpm drive without a fan was pretty warm, but had no vibration at all. The bad drive is only a few years old, and I've never had a drive fail on me in around 10 years of computer use, until now. And until I got this case and drive I'd never had a fan blowing on a drive before. Who knows what caused the problem, but all this has made me wonder: Which is worse for a hard drive? Heat that's fairly warm to the touch, or constant vibration from a case fan right next to it? Any readers care to offer their experiences and knowledge?"

Comments

Heat vs. Vibration

[david4286]

In one of my computers with relatively low ventilation, the relatively old (only 4-5 years) harddrive is in perfect condition. However, in my newer computer, things weren't as perfect. I have a fan on one of the drives (rather loosely conneted, open to vibration), which recently began to malfunction.

However, I believe that the cause of this was overwork and stress on an old and rather weak drive. Have you recently put excessive stress (such as copying entire file systems) on the drive? In all, it seems that heat hasn't played a major factor in disrupting quality in my experiences.

RAID.

[3-State Bit]

Ever since those big drives started dropping like flies (IBM ones I think? It was all over slashdot) I vowed that if my primary computer ever becomes a desktop system again, it will have at least mirrored RAID. (I just mean raid-0).

I've had way too many hard drives fail in my lifetime. (Three).

And I'm only 19.

What a sad, sad, world.

So, yeah.

Re:Solution: Don't use front fans

[Polo]

It's common knowledge that for hard drives, temperature and drive life are inversely proportional.

Hammers.

[stienman]

Definitely hammers.

Aside from hammers, though, heat and vibration, taken together, cause serious problems.

The systems I work on, however, have to deal more more heat than vibration. Badly made hard drive motors, such as those in late model Fujitsu hard drives, create ton of heat - you would burn yourself on them if they didn't have a fan.

If your drives are below 60 degrees celsius (hot, but you won't get burned) then you really don't need to worry about heat.

Vibration is not nearly an issue with today's computers as it was when items were socketted to printed circuit boards and connectors were manufactured to loose tolerances. Now everything is soldered, and if it isn't soldered it uses a tight connector that requires forces measured in kilograms to remove.

Vibration is rarely an issue. Even in a hard drive where magnetic and air forces keep the head microns away from the platter, vibrations are still measured in G's - not fractions of G's. Prolonged constant vibrations can cause increased wear and tear, but not by a lot. In order to make an operating hard drive crash it's heads with the vibration of a fan, you'll have to attach it to the equipment tie down point of an industrial cement kiln fan, and attach a 50lb weight to one of the blades at the edge. Even then, I'd bet on the heads not crashing before the fan bearings break. You're piddly little fan is no match for my flying head air bearing technology!

So, in short, take care of the heat first, but only if it's very hot. Don't worry about warm. If your fan is vibrating then it needs to be cleaned. If you've cleaned it and it is still vibrating, get a new fan - they aren't expensive.

If you're playing the cost tradeoff game then you're playing it wrong. When the question is "What's cheaper: a new vibration free fan, or replacing my hard drive every other year..." the answer is always the new vibration free fan.

Lastly, expect new hard drives to last exactly the length of their warranty, regardless of how you treat them. The profit margin for hard drives today is so thin that it's not worth making one that will last longer than the warranty.

-Adam

Question: Hard Drives used in car Mp3 Players

[jhayworth]

I've seen here where people have mounted desktop hard drives on their side to avoid the read/write heads from banging against the drive platter.

Laptop Hard Drives?

What kind of a hard drive configuration would you use in automobiles?

Just curious,

-- Joshua