Slashdot Mirror

← Back to Stories (view on slashdot.org)

NASA Fiddles With Mars Rover

Posted by michael on from the fingerpoken dept.

binaryDigit writes "The San Jose Mercury News has an article detailing the delay in launching the next Mars rover. Apparently 'a guillotine like device designed to sever the cables could produce a short circuit'. I assume some sort of standard connector was ruled out in this case? Yet another setback for NASA, though they at least caught the problem before launching it and then not being able to do anything about it."

6 of 16 comments (clear)

  1. 2010 by bob_jordan · · Score: 2, Funny

    Didn't anyone watch 2010. All you need is a non-conductive blade and a little red calculator.

    Bob.

    1. Re:2010 by gl4ss · · Score: 2, Informative

      i didnt find it in the article by quick glance.. but i assume that even with non-conductive blade the wires could still short-circuit against each other.

      --
      world was created 5 seconds before this post as it is.
    2. Re:2010 by stj · · Score: 2, Funny

      You forgot one thing: you must ensure that the constructor of the circuit to be disconnected must not be around the device after the blade has been installed.

      --
      iThink iHate iMod
  2. why? by bobba22 · · Score: 2, Interesting

    Forgive my ignorance, but what does this umbilical system do? Surely it can't be to keep the batteries charged on the flight to Mars, especially as they'll be doing very little, comms with the rovers *I assume* will be via RF. I can't believe that a rigid docking system would be less practicable than a severing system. Won't a severing system be fraught with possible problems - dust getting in the mechanism could stop the guillotine action altogether rendering the whole thing useless. What point am I missing here?

    1. Re:why? by EccentricAnomaly · · Score: 3, Insightful

      All of the avionics, the computer, etc. are on board the rover. The umbilical cables connect the rovers to sensors, solar panels, antennas, thrusters, etc on the cruise stage and on the descent stage.

      As far as a rigid docking system... that sounds very unreliable to me. A cable will very reliable be connected when you need it to be connected and you can reliably cut the cable when you need to. Designing a rigid docking system seems like a very difficult problem if you want it to be reliable... and it seems like a waste of effort if you aren't reusing the system....

      The problem isn't with the sytem to cut the umbilical anyway, the problem is with circuits that aren't supposed to be sending a signal through a severed wire... you don't know if two severed wires could touch each other or some other piece of metal. The solution is to not send a signal through the wire after its cut.

      --
      There are 10 types of people in this world, those who can count in binary and those who can't.
  3. I believe that is the standard way by hubie · · Score: 4, Informative
    I assume some sort of standard connector was ruled out in this case?
    Those devices are very common to sever cables and bolts. They are reliable and effective. Essentially they are pyrotechnic devices that fire an explosive charge that drives a knife edge through whatever you want severed---basically a little cannon that shoots out the knife blade. Judging from the short news blurb, it sounds like a problem with the design of the back-end electronics that were supposed to handle the expected severing.