World's First Ultra-Thin Multilayer Circuit Board

neutron_p writes "Seiko Epson has developed the world's first 20-layer circuit board. Multilayer circuit boards are normally produced by using a photolithography. However, the industry has struggled to produce thin, lightweight, high-density multilayer circuit boards. Seiko Epson uses an inkjet-based manufacturing process, which has many advantages over a traditional photolithography process."

Comments

Re:Anyone know if it's bendable?

[Cthefuture]

It sounds like it should be somewhat flexible, although I doubt you would want to move it much because the ink might flake off or crack. It looks like it could produce curved and bent boards though. That would be great for putting electronics in odd shaped housings.

I want the consumer version. This would make it much easier for the hobbiest like myself to make boards. Just print and use. I could see printing out the board on a thin film and then glueing it to a normal thickness material. The only problem I see is how to solder to it. It's a conductive ink so you might need a low-temperature solder or some other method so as to not burn it.