Nanoknives To Be Used to Cut Cells

Roland Piquepaille writes "American researchers have built a carbon nanotube knife. According to the National Institute of Standards and Technology (NIST), this nanoknife will be used to cut and study cells. With this new tool, scientists and biologists will be able to make 3D images of cells and tissues for electron tomography, which requires samples less than 300 nanometers thick. And as cells are usually stored in wax for dissection, the researchers plan to test their nanoknives on a block of wax later this year. But read more for additional references and a picture of this nanoknife."

Comments

I've already seen that

[macadamia_harold]

According to the National Institute of Standards and Technology (NIST), this nanoknife will be used to cut and study cells.

I saw my first nano knife when I brought my nano on the subway in New York. The guy took my wallet, too.

Re:How hard is it to wrap a carbon nanotube?

[imsabbel]

Friction on atomar level isnt what you are used to.

Trying to tie or wrap those nanotypes would be more than futile.

Re:Obligatory

[cyfer2000]

Actually they did. The art of cutting thin slice is called microtomy. Glass knife and diamond knife are used for microtomy. The advantage of glass knife is cost, the glass cost almost nothing. But glass knife doesn't last long, it gets blunt after 20 or 30 cuts. Also glass knife become blunt even you do nothing with it because glass is essentially fluid and the sharp edge has huge surface tension. Diamond knife lasts forever if you don't do anything wrong with it. But the diamond knife is pricey, a single knife can cost several thousand of dollars.

I have been doing microtoming for years. But I don't see how could this can be used to replace diamond knife. Basically we need to trim the sample to 0.1x0.25mm block and cut the block. This is small but still 100um. I at least need a knife of 150um wide to work on this. Nanotubes as long as 150um are not so well available at least for now. Then the knife is a 150um long 10nm thin wire, which I can not see with my eyes. How do I know the wire is stretched? And if it is stretched, during the cutting, the temperature and change from room temperature to -90 degree C. So how do I handle the thermal expansion? Also the problem troubled me mostly is how do I handle the section? When I am using a glass or diamond knife, the section and block fall to different sides of the knife, then I can use special tools to pick the section up. But when the wire cut through the sample, the section sticks back to the block. Also how much the wire knife cost and how long it can last? I can resharpen a 3mm diamond knife for $1500 after I made enough mistakes on it, which can be 5 or 10 years.

However, I really think this thing can be used as a wire saw to make MEMs.