Couple Busted For Shining Laser At Helicopter

coondoggie sends us to another Network World piece, this one about a couple charged with shining a green laser into the cockpit of a police helicopter. The FBI and the US attorney's office charged the California couple under a federal statute. They could end up paying a $250,000 fine and doing 20 years of jail time. "The complaint states that on November 8, 2007, at about 10:55 p.m., a green laser beam illuminated the cockpit of a Kern County Sheriff's Department helicopter, which was flying at 500 feet during routine patrol in Bakersfield, California. When the light hit the cockpit, it disoriented the Kern County Sheriff's pilot, causing pain and discomfort in his eyes for a couple of hours, the FBI said in a statement."

Comments

Re:What kind of laser?

[yakumo.unr]

These are generalisations but :

Presentation pointers are red, very low powered, you can't see the beam without some kind of mist, you can get them for under five pounds in the UK all over the place, normally smaller than a pen, but thicker.

Green lasers are more powerful, you can see the beam in clear conditions, they cost an awful lot more ( somewhere between 100 - 200), are much larger, closer to say, a couple of coke cans stood on end, and can cut through a polystyrene cup....

Or at least that was the case the last time I looked maybe a year ago, I just took the first google hit that caught my eye and unsurprisingly they've got smaller and cheaper now : http://www.thinkgeek.com/gadgets/lights/5a47/

heh, the thinkgeek page even specifically points out "Warning: Green lasers are very powerful. Pointing at aircraft may land you in jail. Without a Monopoly card to get you back out. Use it wisely."

Re:What kind of laser?

[AnalogDiehard]

I am a laser engineer at work (I work with dangerous class IV lasers) and have taken laser safety courses.

Else, infra-red lasers, being completely invisible to the human eye, would not be dangerous at all.

Absolutely positively not true. Laser sources that emit a non-visible beam fall in class IIIR, class IIIB or class IV which are the worst eye hazards regardless of power. ANSI Z136.1 specifies that non-visible class IIIR or higher laser beams must be enclosed to prevent laser radiation exposure to non-trained personnel.

I work around exposed class IV CO2 10600nm laser beams capable of putting out 100 watts (that's watts, not mW) of power. The beam is invisible to the human eye yet it is capable of cutting metal. "Not dangerous at all" is a serious understatement.