Data Recovered From DVD Leads To Conviction, 24-Year Sentence

Lucas123 writes "The Santa Cruz, Calif. DA's office had been counting on a DVD with the recorded testimony of a victim in case against a serial rapist, but when they popped the video into the player, nothing came up — the disc was blank. To make matters worse, the cop who performed the original interview with the victim told the DA she never said she was 'forced,' so the judge wasn't going to allow the witness to testify in a case where her original statement to police was in conflict with her current testimony. After two local data recovery firms said there was no way to restore the data, a third was able to recover the police interview from two years earlier, which led the defendant to plead guilty earlier this month. Close call."

Comments

Re:Only Meta-Data was damaged

[Compholio]

I noticed after burning the disk that there was dust on the bottom (a lot of it concentrated in one spot). So, I blew it off and the part where the dust used to be was distinctly the "not burned" color. For shits and giggles I tried the disk anyway and there were a bunch of inaccessible files. Since I noticed it right away I just chucked the disk and made a new one (I was working with data on a PC). This happened quite a while ago, but if you're curious I could attempt to intentionally reproduce it.

Disc wasn't finalized

[CyberZCat]

This is a very common problem that happens when a disc isn't finalized on both audio CDs and video DVDs that are recorded on direct to disc consumer recording systems. After a the actual data is written what is a essentially a "table of contents" has to be written at the beginning of the disc, otherwise you get the "blank disc" effect as describe here. That two separate data specialists couldn't figure this out is rather concerning...

Re:HOW was Only Meta-Data was damaged?

[dgatwood]

Probably, yeah. In the worst case, though, the disc might have gotten finalized incorrectly (e.g. using a bad optical drive), in which case even the original DVD burner might not play it....

The lead-in area (at least for the first session) is the innermost recordable portion of the media. If something went wrong in media fabrication, I'd expect that to be the second-most likely part to have problems, second only to the outer edge (which fails verification frequently in cheap media). So this could have been a media defect as well.

I'm not surprised the Seagate folks were able to recover the data. This pales compared with what the Seagate recovery folks deal with every day--head crashes, surface mount desoldering and replacing defective head preamps, maybe even electron microscope recovery of shattered platters.... Compared with that, a few bad blocks in the lead-in of a DVD is downright trivial and might even be recoverable without hacking the drive firmware....

That said, I sure would like to know who the two companies are that couldn't figure this out so I can never send anything to them.... :-)