Slashdot Mirror
Seagate Hard Drive Fiasco Grows
AnInkle writes "Two months after acknowledging that their flagship 1.5TB Barracuda 7200.11s could hang while streaming video or during low-speed file transfers, Seagate again faces a swell of complaints about more drives failing just months after purchase. Again, The Tech Report pursued the matter until they received a response acknowledging the bricking issue. Seagate says they've isolated a 'potential firmware issue.' They say there's 'no data loss associated with this issue, and the data still resides on the drive;' however, 'the data on the hard drives may become inaccessible to the user when the host system is powered on.' If users don't like the idea of an expensive data-laden paperweight, Seagate is offering a firmware upgrade to address the matter, as well as data recovery services if needed. By offering free data recovery, Seagate seems to be trying to head off what could become a PR nightmare that may affect several models under both the Seagate and Maxtor brands."
I will always trust Seagate...
...if not to produce 100% failure-proof designs, then to do everything they can to fix the problem and make it right by the costumer.
Years ago I had a Barracuda die and need replacement under warranty. It was real clear when I sent it in that there was NO guarantee of any sort for my data. What I received back was a different drive (different serial) complete with ALL of my data. That's as good as I can ask for.
One thing I've found firsthand is that it isn't always the drive itself that's at fault. I had a similar experience with Seagate - not a single problem before they bought Maxtor (and not the other way around), but problems began to occur in later models. At first, it was just one drive, which I backed up and returned for repairs. They sent me a new one, but that didn't work either. I figured I was done with Seagate and bought a WD drive, which seemed to work for a while.
When it too started experiencing problems, I decided to delve deeper into the problem, suspecting something wrong with the system itself. The root cause was actually my power supply, which was supplying very low voltage on both the 5V and 12V rails. I replaced the supply and all of the drives resumed working properly.