New Electrode Lets Batteries Charge In 10 Seconds

Al writes "A new lithium-ion electrode allows batteries to be charged and discharged in 10 seconds flat. Developed by Gerbrand Ceder, a professor of materials science at MIT, it could be particularly useful where rapid power bursts are needed, such as for hybrid cars, but also for portable electronic devices. In testing, batteries incorporating the electrodes discharged in just 10 seconds. In comparison, the best high-power lithium-ion batteries today discharge in a minute and a half, and conventional lithium-ion batteries, such as those found in laptops, can take hours to discharge. The new high rate electrode, the researchers calculate, would allow a one-liter battery based on the material to deliver 25,000 watts, or enough power for about 20 vacuum cleaners."

Comments

Re:fast enough for a

[sgbett]

first thought?

Railgun

Think about it

[jeffmeden]

Actually, the big thing about electric driving isn't getting started in the first place, it's reclaiming the energy when you have to stop (at least for inner city driving.) If you have a battery that is bordering on a supercapacitor to dump energy into, you can reclaim nearly all of the stopping energy into the battery to use to start again. Given that there are 745 watts/hp, a battery capable of a charge rate of 25KW gives you 33 horsepower of braking capacity with one cell. Get 3 of them in a car and you can reclaim 100hp during a stop, which would be good for all but the most grueling emergency stops (depending on the weight of the car).

Re:20 vacuum cleaners...

[fractoid]

Um, for starters, you're not going to be plugging all those cars in at the same time if each one's only plugged in for 10 seconds.

Secondly, generally EV-sized batteries are fast-charged by using a 'dump pack', an identical fully charged pack of batteries that can supply as much current as the flat one can eat up. The important number is the continuous current draw, not peak.

That's what makes small, high-current batteries so good. Imagine a car window motor which pulls, say, 5 amps at 12 volts. You need to run 5amp wiring to it. But assume that the motor only needs to run for a few seconds at a time, very infrequently - instead of running 5 amp wiring, you can simply put a battery next to the motor that's sufficient to run it for a minute or so, and trickle charge the battery over the car's CAN bus.

Another use (actually this is one I read about where ultracaps are useful) is making a hard drive that doesn't lose data when the power drops during a write operation. Basically the cap would store enough energy for the drive to detect loss of external power, finish writing its buffer, and park itself before it ran flat.