Unspoofable Device Identity Using Flash Memory
wiredmikey writes with a story from Security Week that describes a security silver lining to the inevitable errors that arise in NAND flash chips. By seeking out (or intentionally causing) defects in a given part of the chip, a unique profile can be created for any device using NAND flash which the author says may be obscured, but not reproduced: "[W]e recognize devices (or rather: their flash memory) by their defects. Very much like humans recognize faces: by their defects (or deviations from the 'norm') a bigger nose, a bit too bushy eyebrows, bigger cheeks. The nice twist is that if an attacker manages to read your device identity, he cannot inscribe it into his own device. Yes, he can create errors — like we did. But he cannot control where in the block they occur as this relies solely on microscopic manufacturing defects in the silicon."
Bad blocks are inherent in NAND flash. SLC NAND Flash devices are more reliable (have fewer errors) and costly. MLC NAND Flash devices are less reliable (have more inherent errors) but are affordable and easily available. NAND Flash devices are known to progressively degrade until the number of bad blocks is too high to reliably store data. Inherent errors during manufacturing increase on usage (both read and write.) Most Flash Storage Devices will ultimately become too error-prone to store data. The industry might want to justify inherent errors (and gradually increasing errors) by calling it a fingerprint. They are still searching for techniques to make NAND Flash more reliable.
The article fails to provide mathematical basis to prove that two NAND flashes cannot have the same bad blocks on manufacturing or at some point of usage thereby obscuring identity. NAND flash controllers are designed to check and resolve errors using known algorithms. Most controllers allow hardware to hide errors while allowing OS device drivers to read the NAND flash medium. The Operating System and the NAND Flash Controller are at least two points were any such fingerprint can be compromised. The Filesystem adds another layer of abstraction. The number of "Real" bad blocks and remaps is usually stored on the NAND Flash. Altering the Bad Block Table is not difficult.
Hard Disks interestingly have similar failure rates and complex issues like Data remanence which have been studied. I wonder why no one proposed a signature scheme for using errors on Hard Drive Platters to identify them. Computer Forensics for Hard Drives has a longer track record of being studied. Marketing fud can be ignored.
No Greater Friend, No Greater Enemy! (Lucius Cornelius Sulla)
The device emulator that you suggest would fail a Trusted Platform Module check. From the article: "run a secure boot or a reliable software-based attestation scheme".
you mean I can't create a simple device [...] by using any low-cost prototyping board to spoof a USB interface? Or SATA interface?
Markus Jakobsson wrote in the article:
No need for error-correcting codes; in fact, we will read and write "raw", which is possible since all of this will be done on OS level.
He's talking about using raw NAND flash without a (hardware) controller, which is more than likely soldered to the motherboard. All USB flash drives have a controller performing error correction, as do all CompactFlash, SD, and Memory Stick memory cards. The only popular consumer flash storage devices that don't have a built-in controller are SmartMedia and xD-Picture cards; the controller for these is inside the camera or the USB card reader.
This sounds like an early 80s copy-protection scheme that depended on the bad-sector map of the installed hard drive to identify it. It was reliable because only a low-level format would change the pattern, and very few people ever did a low-level format to their drives. The scheme failed when production improved and most drives could be manufactured error-free.