Equipping a Small Hackerspace?

andy writes "After gentle prodding for about a year, my company actually agreed to include an electronics/robotics lab in the current build-out of our new office space. As I never really expected this to happen, I was at a bit of a loss when they asked me what sort of workbenches, equipment, etc. I wanted for the lab. The lab will only be approximately 9'x15' but there is a decent amount of vertical space to work with. I was thinking of having 2 workbenches side-by-side, one for 'hardware' and the other for 'software' with a floor-standing cabinet for storage. Semi-mobile workbenches might be a plus. Those of you that work in these sorts of environments, what do you recommend in the way of workbenches, storage, organization, and electronics?"

Comments

This is what I have in my lab

[mirix]

Which is sadly under utilized these days (too much real work unfortunately)

Several voltmeters - I like the old Fluke bench units... LED displays you can see across the room, and the batteries are never dead because there are none.
Several scopes - tek is king here.
Drill press - bloody essential for anything mechanical at all.
Logic analyzer, i'm partial to the HP ones
Spectrum analyzer - pricy, but a godsend for RF work (if you'll be doing any) - HP, again.
Power supply - hp made good ones again. you can never have too many it seems. I have some homebrew ones too - ATX supplies and random ebay SMPS units can be handy and dirt cheap, but not adjustable (you can add an external reg easily though..)
Freq counter - hp, but fluke made decent ones. more for RF, but can be handy for digital, clocking and stuff...
Freq gen, whether you need a lower freq audio one or one that does RF depends on what you're planning on.

For soldering irons im partial to the hakko ones, '936' is the model, and there are plenty of knockoffs available on ebay. The genuine model isn't crazy expensive though.

Then a PC, a few programmers, depending on what you want. I'm partial to Atmel's AVR, but PIC is big, some folks are still stuck with moto 6800 derivatives for some unknown reason, likewise with 8051's... For the money ARM is really the way to go, but I havent played with them much yet. Some sort of JTAG unit will be handy for random programming also. I usually use a linux box with avr-gcc, but some tools are win32 only, so might want to have a windows box or virtualbox around - not to mention some schematic / board layout stuff is win only too.

For dev boards, I have a few from atmel, but some of them are pretty pricy. these guys make some nice dev boards, but I'm not crazy about their compiler. The IDE looks nice enough, but I'm used to gcc and my own editor. I have one of their AVR boards, and I use a GPL'd AVR based AVR programmer (chicken and egg if you dont already have one ;) ) with it, because their built in programmers (which work well, mind you) are windows only.