Slashdot Mirror
New York Data Centers Battle Floods, Utility Outages
miller60 writes "At least three data center buildings in lower Manhattan are struggling with power problems amid widespread flooding and utility outages caused by Hurricane Sandy. Flooded basements at two sites took out diesel fuel pumps, leaving them unable to refuel generators on higher levels. One of these was Datagram, which knocked out Buzzfeed and the Gawker network of sites. At 111 8th Avenue, some tenants lost power when Equinix briefly experienced generator problems."
The NY Times has a running list of Sandy-related problems, including 5,700 more flight cancellations, 6 million people without power, rising water levels at a nuclear plant, official disaster declarations from President Obama, and a death toll of 38. On the upside, and despite the high water levels, the Nuclear Energy Institute was quick to point out that all 34 nuclear facilities in Sandy's path made it through without problems.
> Why aren't there more datacenters in Kansas, Nebraska, North Dakota, etc.?
There are, you just dont hear about them as often because they generally dont have anything newsworthy to report about them.
Your hair look like poop, Bob! - Wanker.
5 microseconds per kilometer tends to be a pretty good approximation, depending on the transport gear.
Things like FEC, EFEC, dispersion compensation modules (non-bragg grating type), frequent OEO regens can add up and make it worse.
That would give you a ballpark of 11ms for a 1450 mile circuit.
09 F9 11 02 9D 74 E3 5B D8 41 56 C5 63 56 88 C0
I work for a daatcenter in Kansas. I can tell you first hand that there are a lot of datacenters around here (Kansas City metro). If you aren't doing high speed trading, then you have no reason to not have a datacenter out here. Power is cheaper, space is cheaper, cost of living is cheaper, you don't have to worry about hurricanes or snow, most DCs are tornado proof, and connectivity here is WAY better than people know (and growing faster than any other area in the country). If latency is your primary concern though, then close to the source is your only option.