Slashdot Mirror
Ask Slashdot: Server Room Toolbox?
jandersen writes "I am the system manager in charge of a smallish server room (~50 servers, most in racks), and I am going to buy a set of tools; but first I want to hear what other people think would be a good idea. Certainly a range of good quality screwdrivers — slotted, Phillips, Pozidriv, Torx. But what else? Tape measure? Spirit level (for aligning the racks)? Any meters or cable testers? A wood lathe? I can probably get away with a budget of a few hundred GBP, but there ought to be some mileage in that."
Seriously. Hang a thermometer a foot or two (okay, 30 or 60 centimeters) from the center of the ceiling. Keep an eye on the little guy. Compare it to the thermostat's reading. The "real air" temperature in the room can often be much different than the temperature on the where the thermostat is attached, _especially_ if it's an exterior wall that's being pummeled by sunshine or winds.
I've seen places where the temperature fluctuated so wildly as day and night cycled that it screwed with the equipment, Every time you have a failure document what kind, the thermostat temp and the thermometer temp. If you spot a pattern you might consider calling in the HVAC guys for a recommendation.
This is the dumbest question posted here (in a long time).
You may well be right. However, the stupidest question is always the one that isn't asked.
Because right now you sound like a complete ignorant who don't even know what a server is.
And you sound like somebody who feels the urge to put somebody down because it makes you feel a bit less bad about yourself. Alas, it didn't work - I don't really give a toss about what you say; if you believed in yourself, then you wouldn't be afraid of asking, even if it makes you look less than divine.
And if you look around at the answers I've got, you will see that a number of people have given some very good advice. Some of it I already know, but there are some good, new ideas that I hadn't thought of.
You lose a man point for even asking that.
Man points? Who cares about man points? A real man is not afraid of looking stupid, if he needs to learn. The only stupid question is the one you don't dare to ask.
I agree - real tools are a lot better. A dedicated torx screwdriver is better than a bits version, but you should have a bits screwdriver too.
And then limit the access to the tools so only a few trusted persons have them. Painting them pink or something is a good addition to make them stay at home.
A cheap DMM (able to take DC/AC Volt/Amp/Ohm) and a simple TP cable tester will be good to have too. No need to get the high level equipment, cheap stuff is good enough.
And a flashlight - there will always be that pesky hard to read text somewhere on a device that you can't read without the right light.
If builders built buildings the way programmers wrote programs, then the first woodpecker would destroy civilization.