How NASA Brought the F-1 Rocket Engine Back To Life

First time accepted submitter Martin S. writes "How NASA Engineers have reverse engineered the F1 engine of a Saturn V launcher, because: 'every scrap of documentation produced during Project Apollo, including the design documents for the Saturn V and the F-1 engines, remains on file. If re-creating the F-1 engine were simply a matter of cribbing from some 1960s blueprints, NASA would have already done so. A typical design document for something like the F-1, though, was produced under intense deadline pressure and lacked even the barest forms of computerized design aids. Such a document simply cannot tell the entire story of the hardware. Each F-1 engine was uniquely built by hand, and each has its own undocumented quirks. In addition, the design process used in the 1960s was necessarily iterative: engineers would design a component, fabricate it, test it, and see how it performed. Then they would modify the design, build the new version, and test it again. This would continue until the design was "good enough."'

Comments

Re:Lacked the barest of computer aids?

[Reality Man]

They had CAD applications, just not what you think as CAD. Anyways, this is interesting, because when do you think CAD applications started? Did the whole thing just pop into existence fully formed, or were there intermediary steps?

Just on the electronics side, look at something like SPICE. It didn't pop into existence with a GUI on a personal computer, it started as a punch-card reading batch application on a mainframe. Boom, computer aided design.