Slashdot Mirror
RPiCluster: Another Raspberry Pi Cluster, With Neat Tricks
New submitter TheJish writes "The RPiCluster is a 33-node Beowulf cluster built using Raspberry Pis (RPis). The RPiCluster is a little side project I worked on over the last couple months as part of my dissertation work at Boise State University. I had need of a cluster to run a distributed simulator I've been developing. The RPiCluster is the result. I've written an informal document on why I built the RPiCluster, how it was built, and how it performs as compared to other platforms. I also put together a YouTube video of it running an MPI parallel program I created to demo the RGB LEDs installed on each node as part of the build. While there have certainly been larger RPi clusters put together recently, I figured the Slashdot community might be interested in this build as I believe it is a novel approach to the rack mounting and power management of RPis."
Dude, you should totally mine bitcoins with that bad boy!
A new Raspberry Pi cluster Fram Boise University, eh?
http://blogs.linbit.com/p/406/raspberry-tau-cluster/
Not to diminish your achievements which are otherwise quite cool, but this novel approach to rack mounting is anything but. Quite possibly the single most important feature of a rack is ease of component access. By tying all components together with PCB standoffs you basically can't remove a single RPi if there's ever a pressing need.
If anything you've shown a novel way of cramming things together without the use of a rack.
it looks like the purpose behind this project is to have an "always available" (to this Ph.D. student) 32-node cluster that is dedicated to doing the work which this dissertation student needs to perform in order to complete his Ph.D., and it makes sense to be able to do this for the cost of a single Xeon node in a larger beowulf cluster.
.
This lets him escape the externalities which might impinge on his getting his own work done, like the big bad Beowulf cluster not being up or available when he needs it, or it being prioritized for someone else's project (say a professor who has tenure and more funding available). Those sorts of shenanigans would delay his work. So a 1/3rd speed cluster that's always available for your own project is a helluva good deal at 1/32 the cost of the big bad beowuilf cluster, eh? At least I think so!
Right, but a "vastly superior computing solution" for CFD or linear equations is one thing. Trying to simulate network communications activity for 32 or 33 nodes on a single compute node is probably slower than actually trying out the algorithms on dedicated hardware that instantiates an actual hardware network. Thus, for a project that tries out different networking and communications algorithms, a 3 times more expensive by your calculations might actually end up being 10 times less expensive, especially considering the locking and interprocess communications required in a multi-threaded simulation on a single compute node vs. actually running it on real hardware with 32 nodes and an ethernet network linking the 32 nodes.
.
Especially considering that this system is going to be used for wireless communications protocols, the real hardware solution is IMHO the better way to go.
Raspberry.Pi
Architectural
Messaging
since he says in his pdf document that " My research is currently focused on developing a novel da ta sharing system for wireless sensor networks to facilitate in-network collaborative processing of sensor data. In the process of developing this system it became clear that perhaps the most expedient way to test many of the ideas was to create a distributed simulation rather than developing directly on the final target embedded hardware."
i wish i had done this, therefore you suck.
You seem to be missing the point of this completely. ;) I needed a cluster to test some distributed programs (yes, you can test distributed programs inside a cluster). The cluster itself has nothing to do with my PhD work other than that it is a tool I created to ensure I could test the software I've been developing. As for providing a tutorial on how to do what I did, I was writing this to enable freshman engineers understand what was involved with building the cluster. Not everyone knows Linux, or how simple it is to build a Beowulf cluster.