Slashdot Mirror
World's Smallest Dual-Core ARM Cortex-A9 Module?
DeviceGuru writes "Variscite has unveiled what it claims is the world's tiniest Cortex-A9 system-on-module, measuring 52 x 17mm. The Linux- and Android-compatible DART-4460 board is based on a 1.5GHz dual-core TI OMAP4460 SoC, is available with up to 1GB of DDR2 RAM and 8GB eMMC flash, and can run at 400MHz on just 44mA. The module provides interfaces for display (HDMI, RGB, DSI), wireless (Bluetooth, WiFi), audio, camera, USB, and more, and it consumes as little as 5mA in suspend and 44mA while running from a 3.7V battery at 400 MHz, according to Variscite. And in case you were wondering, the iconic Gumstix form-factor is 12 percent larger, at 58 x 17mm."
If I would have waited about ten more seconds I would have been able to give you the URL to the product page, too
"You're right," Fisheye says. "I should have set it on 'whip' or 'chop.'"
Boards in that sort of arrangement are common as muck and have been for a long time. Then when you want to use it, first you need a baseboard which is beyond the construction capabilities of most hackers (Variscite don't show you the back of the board which will have several specialised, very fine-pitch header connectors) and once you break out the "real-world" connectors, you've got a much larger beast.
If you want something to hack around with, go for a SOM like an RPi, or a Wandboard, or an ODroid, or a BeagleBone, or a Cubieboard, or an OLinuXino, or any of a huge number of other products.
Not to much longer these types if systems will sell for $20, then $10 until they are no longer seen as computers and just in everything. Special box of Captn' Crunch that include include cartoons or a movie on a little system like this, your kids watch them while eating breakfast, once it goes dead you throw the box away like anything else.
With A-7 available for almost 2 years already I can not understand why vendors still producing SoC based on the A-9 chip
http://www.carbondesignsystems.com/virtual-prototype-blog/bid/171998/IP-Selection-ARM-Cortex-A9-or-Cortex-A7
Muchas Gracias, Señor Edward Snowden !
With all these small, smaller and smaller yet again modules popping up left and right for often lower and lower prices - or at least higher performance/price ratios - it gets more and more interesting to decide upon a standard small-size docking connector. This connector should offer access to a display interface, fast external storage, USB, power, etc. Everythin needed to interface it to a 'slab' containing a screen, UI actuators, camera(s), sensors, a power supply and the like.
Using these two components you can 'build' or 'upgrade' those mobile internet devices which currently get left on the shelves because their processing capacity is deemed to anaemic by modern standards. Done right it would not add much to the total price of the device but it would expand the capabilities markedly.
Something like this would not be launched by any big brand as they like the buy-use-retire cycle as it is more profitable - for them. If the standard existed and their was demand in the market that demand *would* be fulfilled from suppliers in China - just look at the amount of Arduino-compatible hardware which is produced there. Since nearly all hardware is produced in China anyway the existence of such a standard would only make it easier for the designers of those low-price mobile internet devices which are currently on offer. It would make those devices more interesting as well. Since there is as good as no brand loyalty to these suppliers they will not care about any reduced profits stemming from the replacement of buy-use-retire by buy-use-upgrade-use-retire - they'd just supply materials for the upgrade cycle.
Time for YetAnotherKickStarterProject...?
--frank[at]unternet.org