Plug In an Ethernet Cable, Take Your Datacenter Offline
New submitter jddj writes: The Next Web reports on a hilarious design failure built into Cisco's 3650 and 3850 Series switches, which TNW terms "A Network Engineer's Worst Nightmare". By plugging in a hooded Ethernet cable, you...well, you'll just have to see the picture and laugh. They write: "The cables, which are sometimes accidentally used in datacenters, feature a protective boot that sticks out over the top to ensure the release tab isn’t accidentally pressed or broken off, rendering the cable useless. That boot would hit the reset button which happened to be positioned directly above port one of the Cisco switch, which causes the device to quietly reset to factory settings."
Are 'config t' and 'write erase' too difficult to remember? Bothered by all those inconvenient keystrokes? Try the new EasyBoot(TM) from Cisco, the most convenient way to reset your router!
Building Better Software
From the article:
The cables, which are sometimes accidentally used in datacenters, feature a protective boot that sticks out over the top to ensure the release
and then
Such a situation could cause a problem in any size datacenter, where these switches and cables are commonly used
So are they commonly used on accident? Accidentally used commonly? I was reading the article to figure out what type of cable was often used, but apparently it's these cables but only by accident all the time.
You're plugging it in wrong.
joke is on you because WE WILL NOT BE SHAMED! #americanpride #fatpride
Every cheeseburger I shove down my throat is stopping a child from eating it, saving that child from obesity. Won't you think of the children?
The judge and my therapist says I shouldn't think of the children so much.