Slashdot Mirror
A $1, Linux-Capable, Hand-Solderable Processor (hackaday.com)
An anonymous reader shares a report: Over on the EEVblog, someone noticed an interesting chip that's been apparently flying under our radar for a while. This is an ARM processor capable of running Linux. It's hand-solderable in a TQFP package, has a built-in Mali GPU, support for a touch panel, and has support for 512MB of DDR3. If you do it right, this will get you into the territory of a BeagleBone or a Raspberry Pi Zero, on a board that's whatever form factor you can imagine. Here's the best part: you can get this part for $1 USD in large-ish quantities. A cursory glance at the usual online retailers tells me you can get this part in quantity one for under $3. This is interesting, to say the least.
The chip in question, the Allwinner A13, is a 1GHz ARM Cortex-A8 processor. While it's not much, it is a chip that can run Linux in a hand-solderable package. There is no HDMI support, you'll need to add some more chips (that are probably in a BGA package), but, hey, it's only a dollar. If you'd like to prototype with this chip, the best options right now are a few boards from Olimex, and a System on Module from the same company. That SoM is an interesting bit of kit, allowing anyone to connect a power supply, load an SD card, and get this chip doing something. Currently, there aren't really any good solutions for a cheap Linux system you can build at home, with hand-solderable chips.
The chip in question, the Allwinner A13, is a 1GHz ARM Cortex-A8 processor. While it's not much, it is a chip that can run Linux in a hand-solderable package. There is no HDMI support, you'll need to add some more chips (that are probably in a BGA package), but, hey, it's only a dollar. If you'd like to prototype with this chip, the best options right now are a few boards from Olimex, and a System on Module from the same company. That SoM is an interesting bit of kit, allowing anyone to connect a power supply, load an SD card, and get this chip doing something. Currently, there aren't really any good solutions for a cheap Linux system you can build at home, with hand-solderable chips.
Unless you want to do it yourself or you have a project that needs it. 5 dollar will get you a Raspberry Pi Zero with a full system minus storage.
Have a look at some youtube videos of hand soldering TQFP, there are loads.
https://www.youtube.com/watch?... for example
I'm happy hand soldering 0.65mm devices and I have done 0.5mm. It is easy enough to do if you are careful however my preferred method is to get a £30 stencil and use solder paste together with hand placement. I then chuck it in my £30 oven and get results good enough that my customers assume that it has been made on a pick and place machine.
Yes it takes a bit of practise and experience but certainly no expensive equipment.
wot no sig