Slashdot Mirror

marcansoft writes "On September 28, Nintendo released a Wii update, titled 4.2. This update was targeted squarely at homebrew, performing sweeping changes throughout the system. It hardly achieved that goal, though, because just two days later a new version of the HackMii installer was released that brings full homebrew capabilities back to all Wii consoles, including unmodified consoles running 4.2. However, as part of their attempt to annoy homebrew users, Nintendo updated the lowest level updateable component of the Wii software stack: boot2 (part of the system bootloader chain). Homebrew users have been using BootMii to patch boot2 in order to gain low level system access and recovery functions (running Linux natively, fixing bricks, etc). The update hasn't hindered this, as users can simply reinstall BootMii after updating (it is compatible with the update). But there's a much bigger problem: Nintendo's boot2 update code is buggy." Read on for more details. "Boot2 had never been updated in retail consoles until now. During BootMii's development, its authors noticed that Nintendo's code had critical bugs and could sometimes permanently brick a console by writing incorrect or unchecked data to flash memory, so they decided to write their own, much safer flashing code. Now, Nintendo has pushed a boot2 update to all Wii users, and the results are what was expected: users are reporting bricks after installing 4.2 on unmodified consoles. Nintendo is currently attempting to censor posts and remove references to homebrew. It is worth noting that the new boot2 does not attempt to block anything or offer any additional protection or functionality. Its sole purpose is to simply replace current versions which may or may not have been modified with BootMii. Another interesting tidbit is that Nintendo is not believed to have any method to repair this kind of brick at a factory, short of replacing the entire motherboard."

marcansoft writes "On September 28, Nintendo released a Wii update, titled 4.2. This update was targeted squarely at homebrew, performing sweeping changes throughout the system. It hardly achieved that goal, though, because just two days later a new version of the HackMii installer was released that brings full homebrew capabilities back to all Wii consoles, including unmodified consoles running 4.2. However, as part of their attempt to annoy homebrew users, Nintendo updated the lowest level updateable component of the Wii software stack: boot2 (part of the system bootloader chain). Homebrew users have been using BootMii to patch boot2 in order to gain low level system access and recovery functions (running Linux natively, fixing bricks, etc). The update hasn't hindered this, as users can simply reinstall BootMii after updating (it is compatible with the update). But there's a much bigger problem: Nintendo's boot2 update code is buggy." Read on for more details. "Boot2 had never been updated in retail consoles until now. During BootMii's development, its authors noticed that Nintendo's code had critical bugs and could sometimes permanently brick a console by writing incorrect or unchecked data to flash memory, so they decided to write their own, much safer flashing code. Now, Nintendo has pushed a boot2 update to all Wii users, and the results are what was expected: users are reporting bricks after installing 4.2 on unmodified consoles. Nintendo is currently attempting to censor posts and remove references to homebrew. It is worth noting that the new boot2 does not attempt to block anything or offer any additional protection or functionality. Its sole purpose is to simply replace current versions which may or may not have been modified with BootMii. Another interesting tidbit is that Nintendo is not believed to have any method to repair this kind of brick at a factory, short of replacing the entire motherboard."

marcan writes "The Homebrew Channel is a tool that can be installed on any Wii (no hardware mods required) that lets you run unsigned homebrew software from an SD card, or upload executables via WiFi or a USBGecko. We've tried to make it friendly for users with a simple GUI, and powerful for developers with direct upload features and reloading which we hope will make testing less painful. The channel can be installed using a DVD if you have a modchip, or using an exploit in Zelda: Twilight Princess which only requires an SD card (or any future hack or booting method). Once installed, it simply shows up as a Channel on the Wii Menu, just like any official channel. Hopefully, this and other recent developments (such as the upcoming devkitPPC r15 toolchain, much improved and with many bugs fixed) will help make the Wii an appealing platform for DIY software. And yes, it also runs Linux."

marcan writes "Comcast users are reporting 'connection reset' errors while loading Google. The problem seems to have been coming and going over the past few days, and often disappears only to return a few minutes later. Apparently the problem only affects some of Google's IPs and services. Analysis of the PCAP packet dumps reveals several injected fake RSTs, which are very similar to the ones seen coming from the Great Firewall of China [PDF]. Did Google somehow get caught up in one of Comcast's blacklists, or are the heuristics flagging Google as a file-sharer due to the heavy traffic?"