Slashdot Mirror
Providing 12V Power to RV-Based Hardware?
jp93023 asks: "I am putting together a mobile computer lab in a converted RV. RVs have a 12v DC system for running most interior lights, built-in appliances, fans and so forth. They have a parallel 120v AC system for providing normal outlets, which is great when you are plugged in. It strikes me that when I am running from battery power (which will be most of the time) I will be expending precious watts converting the 12v from the marine batteries up to 120v, only to convert it right back down to 5, 9, 12, and 20v DC for all the PCs, laptops, etc. The equipment package will include desktops, laptops, digital tape decks, etc., so I'd be planning on bypassing the built-in transformers for everything but the laptops. Have any slashdotters put together a unified low voltage DC power distribution system for such a situation? Would the power savings be worth it? Any pointers to products or plans would be great!"
Will the computers be used when the RV is moving? If not, then why not simply buy a portable generator and use it to supply the AC power? Portable generators are very popular among the RV crowd, so I'm sure that you can find lot's of information on their use (such as here).
There are probably solutions for mounting and wiring the generator so that it can be used while the RV is in motion, but that sounds like a much more difficult problem and may be more than what you need.
This would be far more useful to me as a way to replace the vast array of wall warts and chaotic tangle of black wires which warm my feet.
I'd chop off the devices' wall warts and replace them with some sort of quick-disconnect plug on both sides of the cut wire; this way I could use the wall wart again if I was out of this environment.
EE's, help me here. Let's say I have a single 24VDC bench supply (I'm starting at 110v at home)at 15-20A. I'm thinking that for any item drawing under, say, 500ma, I could build mini step-down regulators (in something like 35mm film canisters) using something in the 78xx series of regulators (i.e. 7805 for 5v). I'd put one of those quick disconnect plugs (mentioned above) on the output, so it would easily and quickly interface with the device.
As for the input to these regulators, I'd like to be able to run one 6-ft. wire around my equipment and let the regulators somehow "vampire" tap (I *think* that what it's called) this one wire (perhaps 12 gauge stranded? thicker? help?!), so the number of wires around my setup are drastically cut down. Is this realistic?
I definitely need input here, so please -- someone in the know reply and correct my errors here. I'm specifically concerned with my lack of knowledge in DC power distribution and power loss, not to mention if anything would be likely to leak power back into the regulator somehow.