Slashdot Mirror
Replacing the Housing on Your Flash Drive?
TheFarmerInTheDell asks: "I managed to wash my USB flash drive this past weekend (note to self: check your pockets better before doing laundry) and to my surprise, it still works. The problem is that the clothes dryer managed to beat up the plastic housing, and it no longer holds the innards in place as it should. Trying to plug the drive into a USB port is a difficult proposition since the whole mechanism slides into the plastic housing, instead of sliding into the USB port. Rather than using a super glue or an epoxy solution to hold the electronics in place, I was thinking that a custom body would be a cool way to go. I can cast it in resin and have whatever shape I want for the drive, but I am not sure that it will be a good thing to do. Has anyone done anything like this, and if so were there any problems? Are there any issues about not having an air space to help dissipate the heat that the chip generates? Aside from the obvious concerns about allowing the drive to fit into the USB port of a computer, is there any reason that the drive cannot be housed in any shape that I want?"
Apparently not.
"Speaking the Truth in times of universal deceit is a revolutionary act." -- George Orwell
Mod the parent redundant, as everyone knows duct tape will fix almost anything.
Someone save me from this sanity.
the casing on one of my flash/thumb/pen/whatever drives was just stupidly big for no good reason, so I took it off. To protect it I just got some clear 5 minute epoxy and layered it on there and just kept turning the the drive while it cured.
You can also put a lanyard hole in a dead space on the board or epoxy something in there and hang it on your keychange. It's working quite well for me.
In Bob we trust.
I got some liquid latex from Home Depot for a similar problem. They talk about using it to coat tool handles, but it works great for coating bare electronics too.
Moderating "-1, Disagree" is simple censorship. Have the guts to post your opinion.
points for duct tape solution. Negative points for suggesting someone not waste a lot of time on tech mod on /.
correct answer is skip work for a few days, spend a ton of time working on some really cool device mod that will make most people say "that guy has waaaay too much free time," post pictures and a step by step of how you did it, let us slash the hell out of your server for a few hours
ôó